Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 2 BGP/MPLS VPN Configuration Commands
Huawei Technologies Proprietary
2-33
Parameter
group-name: Name of a neighbor peer group, consisting of 1 to 47 alphanumeric
characters.
Description
Use the peer enable command to enable a specified peer group.
Use the undo peer enable command to disable a specified peer group.
For IPv4 address family, address switching is enabled by default.
Example
# Enable the peer group 168.
[Quidway-bgp] ipv4-family vpnv4
[Quidway-bgp-af-vpn] peer 168 enable
2.1.38 peer filter-policy export
Syntax
peer group-name filter-policy acl-number export
undo peer group-name filter-policy acl-number export
View
VPNv4 subaddress family view, VPN-instance subaddress family view
Parameter
group-name: Name of a neighbor peer group, consisting of 1 to 47 alphanumeric
characters.
acl-number: IP ACL number ranging from 2000 to 3999. That is, you can use basic ACL
or advanced ACL.
export: Uses the filtering policy for the advertised route and this policy is only effective
for peer groups.
Description
Use the peer filter-policy export command to apply the ACL-based filtering policy to
the advertised route for the peer group.
Use the undo peer filter-policy export command to cancel the configuration.
By default, there is no ACL-based filtering policy.
You can only use the peer filter-policy export command to configure peer group.
Related command: ip as-path-acl, peer as-path-acl and peer filter-policy export.
To Next Page
Loading...
