Huawei Quidway S8500 Series User Manual

Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 2 BGP/MPLS VPN Configuration Commands
Huawei Technologies Proprietary
2-30
Example
# Allow the internal BGP session to use any operable interface for a TCP connection.
[Quidway-bgp] ipv4-family vpn-instance test
[Quidway-bgp-af-vpn-instance] peer 1.1.1.1 connect-interface loopback 0
2.1.33 peer default-route-advertise
Syntax
peer group-name default-route-advertise
undo peer group-name default-route-advertise
View
VPN-instance subaddress family view
Parameter
group-name: Name of a neighbor peer group, consisting of 1 to 47 alphanumeric
characters.
Description
Use the peer default-route-advertise command to enable a peer (group) to transmit a
default route.
Use the undo peer default-route-advertise command to remove the existing
configuration.
By default, a peer (group) does not transmit a default route.
This command does not require any default route in the routing table but transmits a
default route whose next hop address is itself to the peer unconditionally.
Example
# Enable the peer group test to transmit a default route.
[Quidway-bgp] ipv4-family vpn-instance a
[Quidway-bgp-af-vpn-instance] peer test default-route-advertise
2.1.34 peer default-route-advertise vpn-instance
Syntax
peer ip-address default-route-advertise vpn-instance vpn-instance name
undo peer ip-address default-route-advertise vpn-instance vpn-instance name
View
VPNv4 subaddress family view

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English