Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 1 Static Route Configuration Commands
Huawei Technologies Proprietary
1-1
Chapter 1 Static Route Configuration Commands
 Note:
When a switch runs a routing protocol, it can perform the router functions. A router that
is referred to in the following or its icon represents a generalized router or an S8500
series routing switch running routing protocols. To improve readability, this will not be
described in the other parts of the manual.
For the configuration of VPN instance, refer to the MPLS module in Quidway S8500
Series Routing Switches Operation Manual.
1.1 Display Commands of the Routing Table
1.1.1 display ip routing-table
Syntax
display ip routing-table
View
Any view
Parameter
None
Description
Use display ip routing-table command to view the routing table summary.
This command displays routing table information in summary form. Each line
represents one route. The contents include destination address/mask length, protocol,
preference, metric, next hop and output interface.
Only current used route, namely, best route, is displayed using display ip
routing-table command.
Example
# View the summary of the routing table.
<Quidway> display ip routing-table
Routing Table: public net