Huawei Quidway S8500 Series User Manual

Command Manual – Reliability
Quidway S8500 Series Routing Switches Chapter 2
HA Configuration Commands
Huawei Technologies Proprietary
2-2
Description
Use the display switchover state command to view the switchover state of master or
slave board.
This command is used to display the switchover state of master or slave board
according to the specified slot number. If slot-id is not specified, the status of SRPU will
be displayed.
Example
# Display the switchover state of master board.
<Quidway> display switchover state
HA FSM State(master): Slave is absent.
2.1.3 display xbar
Syntax
display xbar
View
System view
Parameter
None
Description
Use the display xbar command to view the load mode of master and slave boards,
which includes the configured system Xbar load mode and the active system Xbar load
mode.
Note that the configured system Xbar load mode is not always the same as the active
system Xbar load mode. Only when the slave board is in position or is started, can the
system operate in the configured load mode.
Example
# Display the load mode of the master/slave board.
<Quidway> display xbar
The configured system HA Xbar Load Mode is BALANCE
The active system HA Xbar Load Mode is SINGLE
2.1.4 slave auto-update config
Syntax
slave auto-update config

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English