Huawei Quidway S8500 Series - Port-Isolate Group

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 6 Port Isolation Configuration Commands
Huawei Technologies Proprietary
6-2
Parameter
isolate-group-id: Isolated group number, ranging from 1 to 64. The system supports 64
isolated groups.
Description
Use the port-isolate uplink-port group command to configure the port as an
upstream port.
Use the undo port-isolate uplink-port group command to cancel the configuration.
By default, no upstream port is configured.
Note that:
z You can configure an upstream port for the isolated group only after you create the
isolated group.
z An upstream port can be an aggregation group, but not a static or dynamic
aggregation group
z An upstream port cannot serve as both an isolated port and an upstream port of
the same isolated group
Example
# Configure port Ethernet2/1/1 as an upstream port.
<Quidway> system-view
[Quidway]interface Ethernet2/1/1
[Quidway-Ethernet2/1/1] port-isolate uplink-port group 1
6.1.3 port-isolate group
Syntax
port-isolate group isolate-group-id
undo port-isolate group
View
Ethernet port view/RPR port view
Parameter
isolate-group-id: Isolated group number, ranging from 1 to 64. The system supports 64
isolated groups.
Description
Use the port-isolate group command in port view to configure the port as an isolated
port of the isolated group.
Use the undo port-isolate group command to cancel the configuration.