Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-6
This command displays the information of the enabled IS-IS interface, including
interface name, IP address of the interface, link state of the interface and so on.
Besides displaying all the information shown by the display isis interface command,
the display isis interface verbose command displays such information about the
IS-IS parameters of the interface as CSNP packet broadcast interval, Hello packet
broadcast interval and invalid number of Hello packet.
Example
# Display the information about the enabled IS-IS interface.
<Quidway> display isis interface
Interface IP Address Id Link.Sta IP.Sta MTU Type DIS
Vlan-interface1 172.16.1.2 001 Up Up 1497 L1 Yes
# Display the details of the IS-IS enabled interface.
<Quidway> display isis interface verbose
Interface IP Address Id Link.Sta IP.Sta MTU Type DIS
Vlan-interface1 172.16.1.2 001 Up Up 1497 L1 Yes
Secondary IP Address :
SNPA Address : 00e0.fc44.5f71
Csnp Interval : L1 10 L2 10
Hello Interval : L1 10 L2 10
Hold Time : L1 30 L2 30
Lsp Interval : 33
Cost : L1 10 L2 10
Priority : L1 64 L2 64
Retransmission interval : 5
4.1.6 display isis lsdb
Syntax
display isis lsdb [ [ l1 | l2 | level-1 | level-2 ] | [ [ LSPID | local ] | verbose ]* ]*
View
Any view
Parameter
l1 and Level-1: Both refer to the link state database of Level-1.
l2 and level-2: Both refer to the link state database of Level-2.
LSPID: Specifies the LSPID of the Network-entity-title.
local: Displays the LSP information generated locally.
verbose: Configures to display the verbose information of the link state database.
To Next Page
Loading...
