Huawei Quidway S8500 Series - Peer Reflect-Client; Peer Route-Policy Export

Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches
Chapter 7 MBGP Multicast Extension
Configuration Commands
Huawei Technologies Proprietary
7-24
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] bgp 100
[Quidway-bgp] ipv4-family multicast
[Quidway-bgp-af-mul] peer test public-as-only
7.1.34 peer reflect-client
Syntax
peer group-name reflect-client
undo peer group-name reflect-client
View
IPv4 multicast sub-address family view
Parameter
group-name: Name of the peer group.
Description
Use the peer reflect-client command to configure a peer (group) as a client of the
route reflector.
Use the undo peer reflect-client command to remove the configuration.
By default, there is no route reflector in the autonomous system.
Example
# Configure peer group “test” as the client of the route reflector.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] bgp 100
[Quidway-bgp] ipv4-family multicast
[Quidway-bgp-af-mul] peer test reflect-client
7.1.35 peer route-policy export
Syntax
peer group-name route-policy policy-name export
undo peer group-name route-policy policy-name export
View
IPv4 multicast sub-address family view