Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 2 BGP/MPLS VPN Configuration Commands
Huawei Technologies Proprietary
2-23
Parameter
ip-address: Network address advertised by BGP in dotted decimal format.
address-mask: Mask of the network address.
policy-name: Name of the routing policy applied to the advertised route.
Description
Use the network command to configure the network route advertised to the outside by
local BGP.
Use the undo network command to cancel the configuration.
By default, local BGP does not advertise any route to the outside.
Example
# Configure local router to advertise the routing with the destination network segment
10.0.0.0/16.
[Quidway-bgp-af-vpn-instance] network 10.0.0.1 255.255.0.0
2.1.26 ospf
Syntax
ospf process-id [ router-id router-id-number ] [ vpn-instance vpn-instance-name ]
undo ospf process-id
View
System view
Parameter
process-id: OSPF Process ID. The default process ID is 1.
router-id-number: Router ID for an OSPF process. It is optional.
vpn-instance-name: VPN instance bound to an OSPF process.
Description
Use the ospf command to enable an OSPF process.
Use the undo ospf command to disable an OSPF process.
After enabling an OSPF process, you can perform the configuration related to OSPF in
the OSPF protocol view.
By default, OSPF protocol is not used in the system.
VRP supports multiple OSPF processes, so you can specify different process IDs to
enable multiple OSPF processes on a router.
To Next Page
Loading...
Need help?
General