Huawei Quidway S8500 Series - Chapter 3 VPLS Configuration Commands; Bandwidth

Command Manual – NAT&URPF&VPLS
Quidway S8500 Series Routing Switches Chapter 3
VPLS Configuration Commands
Huawei Technologies Proprietary
3-1
Chapter 3 VPLS Configuration Commands
 Note:
The service processor cards mentioned in this chapter mainly refer to LSB1VPNB0
cards.
3.1 VPLS Configuration Commands
3.1.1 bandwidth
Syntax
bandwidth vpn-speed
View
VSI-LDP view
Parameter
vpn-speed: VSI rate limitation.
Description
Use the bandwidth command to configure VPN rate limitation in the range of 64 kbps
to 4,194,303 kbps with the increment of 64. After the configuration, the system
automatically takes the biggest number that can be exactly divided by 64 and is no
more than the setting number as the rate limitation. The actually supported rate
limitation ranges from 64 kbps to 2,097,152 kbps, and if the value you set is above
2,097,152 kbps, no rate limitation is performed. In the instance, the part of traffic
beyond this bandwidth restriction is discarded by the system.
By default, the VSI rate limitation is 102,400 kbps.
Example
# Set the bandwidth restriction for the VPLS instance Huawei to 10 Mbps.
[Quidway-vsi-Huawei-ldp] bandwidth 10240