Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-26
View
Interface view
Parameter
time: Specifies the LSP interval, ranging from 1 to 1000 and measured in milliseconds.
The default value is 33 milliseconds.
Description
Use the isis timer lsp command to configure the interval at which IS-IS sends
link-state packets on the interface.
Use the undo isis timer lsp command to restore the default setting.
Related command: isis timer retransmit.
Example
# Set the LSP interval on Interface Vlan-interface 10 to 500 milliseconds.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] isis timer lsp 500
4.1.29 timer lsp-generation
Syntax
timer lsp-generation x y z [ level-1 | level-2 ]
undo timer lsp-generation [ level-1 | level-2 ]
View
IS-IS view
Parameter
x: Maximum interval (in seconds) for generating LSP. It ranges from 1 to 120 and
defaults to 5.
y: Interval (in milliseconds) between each trigger operation and each LSP generation
operation. It ranges from 1 to 120,000 and defaults to 5,000.
z: Interval (in milliseconds) between two successive LSP generation operations. It
ranges from 1 to 120,000 and defaults to 5,000.
level-1: Sets interval for Level-1 LSP only.
level-2: Sets interval for Level-2 LSP only.
If neither level-1 nor level-2 is specified in this command, this command takes effect on
both levels by default.
To Next Page
Loading...
