Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-52
The channels for filtering in all the directions are specified by this configuration
command. All the information will be sent to the corresponding directions through the
specified channels. You can configure the channels in the output direction, channel
filter information, filtering and redirecting of all kinds of information.
At present, the system distributes an information channel in each output direction by
default, shown as follows:
Table 4-13 Default information channel in each output direction
Output direction Information channel name
Console
console
Monitor
monitor
Info-center loghost
loghost
Log buffer
logbuffer
Trap buffer
trapbuffer
snmp snmpagent
Log file logfile
In addition, each information channel has a default record with the module name
“default” and module number as 0xffff0000. However, for different information channel,
the default log, trap and debugging settings in the records may be different with one
another. Use default configuration record if a module does not have any specific
configuration record in the channel.
Example
# Configure to enable the log information of VLAN module in SNMP channel and allows
the output of the information with a level higher than emergencies.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] info-center source vlan channel snmp log level emergencies
4.6.16 info-center timestamp
Syntax
info-center timestamp { log | trap | debugging } { boot | date | none }
undo info-center timestamp { log | trap | debugging }
View
System view
To Next Page
Loading...
