Huawei Quidway S8500 Series - Speed

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-22
View
Ethernet port view
Parameter
None
Description
Use the shutdown command to disable the Ethernet port.
Use the undo shutdown command to enable the Ethernet port.
By default, the Ethernet port is enabled.
Example
# Enable Ethernet port Ethernet2/1/1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Ethernet2/1/1
[Quidway-Ethernet2/1/1] undo shutdown
1.1.25 speed
Syntax
speed { 10 | 100 | 1000 | 10000 | auto }
undo speed
View
Ethernet port view
Parameter
10: Speed on the port is 10 Mbps.
100: Speed on the port is 100 Mbps.
1000: Speed on the port is 1000 Mbps.
10000: Speed on the port is 10 Gbps.
auto: Port speed is in peer auto-negotiation status.
Description
Use the speed command to configure the port speed.
Use the undo speed command to restore the default speed.
By default, the speed is auto.
Related command: duplex.