Command Manual – NAT&URPF&VPLS
Quidway S8500 Series Routing Switches Chapter 3
VPLS Configuration Commands
Huawei Technologies Proprietary
3-11
Related command: vsi, vsi-id.
Example
# In VPLS-LDP view, create a user convergence node PE in hierarchical VPLS
architecture with the IP address 4.4.4.4, and set the VC ID for the UPE to 200.
[Quidway-VPLS-Huawei-ldp] peer 4.4.4.4 vc-id 200 upe
# Configure 4.4.4.4 as the IP address of the primary PE (primary link) and 5.5.5.5 as the
IP address of backup PE (backup link) in the beginning. When primary PE is not
available, the backup PE will be switched to the available state.
[Quidway-vsi-vpn1-ldp]peer 4.4.4.4 backup-peer 5.5.5.5
[Quidway-vsi-vpn1-ldp]peer 5.5.5.5 primary-peer 4.4.4.4
3.1.13 pwsignal
Syntax
pwsignal [ ldp ]
View
VSI view
Parameter
ldp: Makes the VPLS uses the martini mode.
Description
Use the pwsignal command to specify a PW signaling protocol for VPLS and enter
VPLS protocol view.
When you specify Martini as the VPLS connection mode, you will enter VSI-LDP view
at the same time.
By default, Martini is used for the VPLS connection mode.
Example
# Set the connection mode of the VPLS instance Huawei to Martini and enter VSI-LDP
view.
[Quidway-vsi-Huawei] pwsignal ldp
[Quidway-vsi-Huawei-ldp]
3.1.14 qos
Syntax
qos { 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | { user-define-table p p p p p p p p } }
To Next Page
Loading...
Need help?
General