Command Manual – Security
Quidway S8500 Series Routing Switches
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
Huawei Technologies Proprietary
2-33
undo nas-ip
View
RADIUS scheme view
Parameter
ip-address: Source IP address which is expressed in the format of dotted decimal
notation.
Description
Use the nas-ip command to configure the source IP address which NAS switch uses to
send RADIUS packets. In this case, all the packets sent to Radius server carry the
same source IP address.
Use the undo nas-ip command to undo the configuration.
By specifying the source IP address used in sending Radius packets, you can avoid
unreachability of packets back from the server when the physical interface fails. It is
recommended to use the Loopback interface address.
By default, the source IP address of packets is the IP address of the VLAN interface to
which the port connecting with the server belongs.
Related commands: display radius, radius nas-ip
Example
# Configure the IP address that NAS (switch) uses to send RADIUS packets as
10.1.1.1.
[Quidway] radius scheme test1
[Quidway-radius-test1] nas-ip 10.1.1.1
2.2.12 primary accounting
Syntax
primary accounting ip-address [ port-number ]
undo primary accounting
View
RADIUS scheme view
Parameter
ip-address: IP address, in dotted decimal format.
port-number: Specifies UDP port number. ranging from 1 to 65535.
To Next Page
Loading...
Need help?
General