Command Manual – Getting Started
Quidway S8500 Series Routing Switches Chapter 2
Password Control Configuration Commands
Huawei Technologies Proprietary
2-4
2.1.5 password-control
Syntax
password-control { aging aging-time | length length | login-attempt login-times
[ exceed { lock | unlock | locktime
[ time ] } ]
| history max-record-num | alert-before-expire alert-time | authentication-timeout
authentication-timeout }
undo password-control { aging | length | login-attempt | history |
alert-before-expire | authentication-timeout | exceed { lock | unlock | locktime } }
View
System view
Parameter
aging-time: Configures the system password aging time. Value range 1 to 365 days,
and the default value is 90 days.
Length: Configures the minimum password length. The value range is 4 to 32
characters, and the default value is 10 characters.
login-Times: Configures the maximum number of login attempts for each user. The
value range is 2 to 10, and the default value is 3.
max-record-num: Configures the maximum number of history password records for
each user. The value range is 2 to 10; default: 4.
alert-time: Configures the alert time before password expiration. The value range is 1 to
30 days, and the default value is 7 days.
authentication-timeout: Configures the timeout time for user authentication; The value
range is 30 to 120 seconds, and the default value is 60 seconds.
Exceed: Configures the processing mode after failed login attempts.
Lock: Locks the login user so that the user will not be able to log in to the switch until
the administrator removes the user from the blacklist manually.
locktime [ time ]: Specifies the time during which the user is locked. The value range is
3 to 360 seconds, and the default value is 120 seconds. A locked user can log in to the
switch again after the configured lock time.
Unlock: The user can still log in after failed login attempts, without being locked.
The default processing mode is the locktime mode after password authentication fails.
Namely, the system will lock the user, and allow the user to log in to the switch after the
configured period of time.
To Next Page
Loading...
Need help?
General