Huawei Quidway S8500 Series - Apply Tag; Display Ip Ip-Prefix

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 6 IP Routing Policy Configuration Commands
Huawei Technologies Proprietary
6-7
Description
Use the apply origin command to configure to apply the route source.
Use the undo apply origin command to cancel the Apply sub-statement.
Related command: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, apply ip next-hop, apply
local-preference, apply cost, apply tag.
Example
# Define an Apply sub-statement. When it is used for setting route information attribute,
it sets the route source of BGP route information as IGP.
[Quidway-route-policy] apply origin igp
6.1.9 apply tag
Syntax
apply tag value
undo apply tag
View
Route policy view
Parameter
value: Specifies the tag value of route information.
Description
Use the apply tag command to configure to set the tag area of OSPF route information.
Use the undo apply tag command to cancel the Apply sub-statement.
Related command: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, apply ip next-hop, apply
local-preference, apply cost, apply origin.
Example
# Define one Apply sub-statement. When it is used for setting route information
attribute, it sets the tag area of route information as 100.
[Quidway-route-policy] apply tag 100
6.1.10 display ip ip-prefix
Syntax
display ip ip-prefix [ ip-prefix-name ]