Huawei Quidway S8500 Series - Frame-Format; Port-Type

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 4 RPR Port Configuration Commands
Huawei Technologies Proprietary
4-16
4.1.12 frame-format
Syntax
frame-format { sdh | sonet }
undo frame-format
View
RPR POS physical port view
Parameter
sdh: Indicates the two RPR physical ports use SDH physical encapsulation.
sonet: Indicates the two RPR physical ports use SDH physical encapsulation.
Description
Use the frame-format command to configure the framing mode if it is FRAMER at the
physical layer.
Use the undo frame-format command to restore the default configuration. The default
encryption mode is SDH.
Example
#Configure the RPR ports to use SDH physical encapsulation.
<Quidway> system-view
[Quidway] interface RPR 2/1/1.1
[Quidway- RPR 2/1/1.1]Frame-format SDH
4.1.13 port-type
Syntax
port-type { 10gpos | 10ge }
View
RPR logical port view
Parameter
10gpos: 10gpos physical port type.
10ge: 10ge physical port type.
Description
Use the port-type command to set physical port type. When the setting changes, the
board will restart automatically, and then switch to new RPR port type.