Command Manual – VLAN&QinQ
Quidway S8500 Series Routing Switches Chapter 1
VLAN Configuration Commands
Huawei Technologies Proprietary
1-10
Related command: display interface.
Example
# Display the protocol information and protocol index configured on Ethernet2/1/1.
<Quidway> display protocol-vlan interface ethernet2/1/1
Interface:Ethernet2/1/1
Vlan-ID Protocol-Index Protocol-Type
100 1 etype ethernetii
1.3.2 display vlan-protocol-vlan vlan
Syntax
display protocol-vlan vlan { vlan-list | all }
View
Any view
Parameter
vlan-list: Specifies a VLAN list. It is expressed in the form of vlan-list = { vlan-id [ to
vlan-id ] } &<1-10>, where the vlan-id after the keyword to must be larger than or equal
to the vlan-id before to. &<1-10> represents that the preceding parameter can be
repeated up to 10 times.
all: Displays the protocol information of all VLANs.
Description
Use the display protocol-vlan vlan command to view the protocol information and
protocol index configured for a VLAN, to which you can refer when you use the
protocol-based VLAN and add/delete a protocol.
Related command: display vlan.
Example
# Display the protocol information and protocol index configured on the VLAN 522.
<Quidway> display protocol-vlan vlan 522
VLAN ID: 522
VLAN Type: Protocol-based VLAN
Protocol-Index Protocol-Type
0 ethernetii etype 0x0600
1 llc dsap 0x12 ssap 0x34
2 snap etype 0x0600