Huawei Quidway S8500 Series - Reset Lanswitch

Command Manual – Integrated Management
Quidway S8500 Series Routing Switches Chapter 1
HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-16
Field Description
2000 0 |X - - - -|- - - - -|-
- - - -|- - - - -|- - - - X|X X
The numbers 0 and 2000 stand for VLAN Index and
VLAN ID respectively. The symbol |- X - - -|- - - - -|- - - -
-|- - - - -|- - - - X|X X indicates the states of the
corresponding ports. As mentioned above, the symbol
“—” indicates a port is not in the corresponding VLAN
broadcast domain. The symbol “x” indicates a port is in
the corresponding VLAN broadcast domain
1.1.13 reset lanswitch
Syntax
reset lanswitch { lanswitch-loc }
View
HGMP view
Parameter
lanswitch-loc: Ethernet switch position parameter, a string that comprises slot number,
subslot number, port number, and sequence number.
Description
Use the reset lanswitch command to reset the Ethernet switches connected to the
management device. As all the services provided by an Ethernet switch are terminated
when you reset the Ethernet switch, use this command with caution.
Only Ethernet switches that register with the management device successfully and
operate properly can be reset.
You can use the display lanswitch command to obtain register information about an
Ethernet switch registration.
Related command: display lanswitch.
Example
# Reset the Ethernet switch with a position parameter of 0/1/6-/.
[Quidway-hgmp] reset lanswitch 0/1/6-/
Reset lanswitch will break service, are you sure? [y/n]y
Waiting....
Resetting LANSWITCH[3/1/6-/] successfully!