EasyManuals Logo

Huawei Quidway S8500 Series User Manual

Huawei Quidway S8500 Series
1341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #719 background imageLoading...
Page #719 background image
Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 1 MPLS Basic Configuration Commands
Huawei Technologies Proprietary
1-9
undo static-lsp egress lsp-name
View
MPLS view
Parameter
lsp-name: LSP name
interface-type Interface-number: Interface type, interface number.
in-label-value: Value of inbound label, ranging 3 (implicit empty label) and from 16 to
1023.
Description
Use the static-lsp egress command to configure a static LSP for an egress LSR.
Use the undo static-lsp egress command to delete an LSP for an egress LSR.
Related command: static-lsp ingress, static-lsp transit and debugging mpls.
Example
# Configure a static LSP named bj-sh on the egress LSR.
<Quidway>system-view
[Quidway-mpls] static-lsp egress bj-sh incoming-interface vlan-interface 201
in-label 233
1.1.12 static-lsp ingress
Syntax
static-lsp ingress lsp-name { destination dest-addr { addr-mask | mask-length } |
l2vpn } nexthop next-hop-addr } } out-label out-label-value
undo static-lsp ingress lsp-name
View
MPLS view
Parameter
lsp-name: LSP name
dest-addr: Destination IP address.
addr-mask: Destination IP address mask.
mask-length: Mask length of destination IP address
next-hop-addr: Next-hop address.

Table of Contents

Other manuals for Huawei Quidway S8500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S8500 Series and is the answer not in the manual?

Huawei Quidway S8500 Series Specifications

General IconGeneral
BrandHuawei
ModelQuidway S8500 Series
CategorySwitch
LanguageEnglish

Related product manuals