Huawei Quidway S8500 Series - Debugging Ppp

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 3 POS Port Configuration Commands
Huawei Technologies Proprietary
3-5
Field Description
Tx Clock Source Clock mode
Clock Grade: Quality unknown(existing
synchronization network)
Clock stratum
SPE Scrambling Current state of scrambling function
SDH alarm:
section layer: OOF LOF LOS
line layer: AIS
path layer: AIS
C2(Rx) :0xff C2(Tx): 0x16
J0(Rx):
J0(Tx):
J1(Rx):
J1(Tx):
BER thresholds: SD = 10e-6 SF =
10e-3
SDH alarm information
SDH error:
section layer: B1 287853060
line layer: B2 0 M1 0
path layer: B3 0 G1 0
SDH error information
Last 5 minutes output: 0 packets/sec 0
bits/sec
Last 5 minutes input: 0 packets/sec 0
bits/sec
Input and output rates in the last five
minutes on the port
input: 0 packets, 0 bytes
0 errors, 0 CRC, 0 giants
0 pads, 0 aborts, 0 overflows
Output: 0 packets, 0 bytes
0 errors, 0 underflows
Input/output packet and error statistics
on the port
3.1.5 debugging ppp
Syntax
debugging ppp { { ipcp | lcp } { all | error | event | packet | state } | all | core event |
ip packet | mpls-multicast packet | mpls-unicast packet | osi-npdu } [ interface
{ aux | pos } interface-number ]
undo debugging ppp { { ipcp | lcp } { all | error | event | packet | state } | all | core
event | ip packet | mpls-multicast packet | mpls-unicast packet | osi-npdu }
[ interface { aux | pos } interface-number ]