Command Manual – Integrated Management
Quidway S8500 Series Routing Switches Chapter 1
HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-48
Table 1-16 Description on the fields of the search multiaddr command
Field Description
No Multicast group number
ErrNo
Error number, which are described as follows:
z 0: The operation is successful
z 1: MAC address error
z 2: VLAN ID out of range
z 5: No address table found
Mac-Address Multicast address
Port Port number
Aged Indicates whether the entry can be aged
PortMask
Port mask, which indicates the ports in a multicast group. For
example, value of 0 indicates the multicast group contains no
port; value of 10 indicates the multicast group contains port 2;
value of 110 indicates the multicast group contains ports 2 and
3; value of 10101 indicates the multicast group contains ports 1,
3 and 5; and so on..
McType
Indicates how a multicast group forwards data to CPU. The
meanings of its value are:
z 0: Do not forward to CPU
z 1: Forward to CPU
z 2: Forward IGMP packets to the CPU
1.3.25 search uniaddr
Syntax
search uniaddr mac-addr-list
View
lanswitch view
Parameter
mac-addr-list: List of MAC addresses to be searched. This argument can contain up to
four MAC addresses.
Description
Use the search uniaddr command to search specified unicast address entries in the
address table of an Ethernet switch.
To Next Page
Loading...
