Huawei Quidway S8500 Series User Manual

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-12
[Quidway-Vlan-interface10] rip version 2
[Quidway-Vlan-interface10] rip authentication-mode md5 usual aaa
2.1.14 rip input
Syntax
rip input
undo rip input
View
Interface view
Parameter
None
Description
Use the rip input command to allow an interface to receive RIP packets.
Use the undo rip input command to disable an interface to receive RIP packets.
By default, all interfaces except loopback interfaces are enabled to receive RIP
packets.
This command is used in cooperation with the other two commands: rip output and rip
work. Functionally, rip work is equivalent to rip input & rip output. The latter two
control the receipt and the transmission of RIP packets respectively on an interface.
The former command equals the functional combination of the latter two commands.
Related command: rip output, rip work.
Example
# Specify Vlan-interface 10 not to receive RIP packets.
[Quidway-Vlan-interface10] undo rip input
2.1.15 rip metricin
Syntax
rip metricin value
undo rip metricin
View
Interface view

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English