Huawei Quidway S8500 Series - Nesting-Vpn; Network

Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 2 BGP/MPLS VPN Configuration Commands
Huawei Technologies Proprietary
2-22
[Quidway] bgp 100
[Quidway–bgp] ipv4-family vpn-instance abc
[Quidway-bgp-af-vpn-instance]
# Enter VPNv4 subaddress family view.
[Quidway] bgp 100
[Quidway-bgp] ipv4-family vpnv4 unicast
[Quidway-bgp-af-vpn]
2.1.24 nesting-vpn
Syntax
nesting-vpn
undo nesting-vpn
View
BGP-VPNv4 sub-address family view
Parameter
None
Description
Use the nesting-vpn command to enable the nested VPN function.
Use the undo nesting-vpn command to disable this function.
By default, the nested VPN function is disabled.
If VPNv4 route advertisement is needed for a CE connected to a PE, the nested VPN
function must be enabled on the PE.
Example
# Enable the nested VPN function.
[Quidway-bgp-af-vpn] nesting-vpn
2.1.25 network
Syntax
network ip-address [ address-mask ] [ route-policy policy-name ]
undo network ip-address [ address-mask ] [ route-policy policy-name ]
View
VPN-instance subaddress family view