Huawei Quidway S8500 Series - Default-Route-Advertise

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-4
Parameter
adjacency: IS-IS adjacency related packets.
all: All IS-IS related debugging information.
authentication-error: IS-IS authentication errors.
checksum-error: IS-IS checksum errors.
circuit-information: Information about IS-IS enabled interface.
configuration-error: IS-IS configuration errors.
datalink-receiving-packet: Data link layer's packets-receiving status.
datalink-sending-packet: Data link layer's packets-sending status.
general-error: IS-IS error information.
interface-information: Information about IS-IS enabled data link layer.
memory-allocating: IS-IS memory allocating status.
receiving-packet-content: Packets received through IS-IS protocol.
restart-events: IS-IS restart evetns.
self-originate-update: Packets locally updated through IS-IS protocol.
sending-packet-content: Packets sent through IS-IS protocol.
snp-packet: CSNP/PSNP packet of IS-IS.
spf-event: IS-IS SPF events.
spf-summary: Statistics about IS-IS performing SPF calculation.
spf-timer: IS-IS SPF trigger events.
task-error: IS-IS events status.
timer: IS-IS timer.
update-packet: Updated packets through IS-IS protocol.
Description
Use the debugging isis command to enable IS-IS debugging.
Use the undo debugging isis command to disable the function.
Example
# Enable all the information debugging of IS-IS.
<Quidway> debugging isis all
4.1.4 default-route-advertise
Syntax
default-route-advertise [ route-policy route-policy-name ]