Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 6 MSDP Configuration Commands
Huawei Technologies Proprietary
6-12
View
MSDP view
Parameter
name: Name of a Mesh Group, being case sensitive. The maximum length is 32
characters.
peer-address: Address of an MSDP peer to be a member of the Mesh Group.
Description
Use the peer mesh-group command to configure an MSDP peer to join an Mesh
Group.
Use the undo peer mesh-group command to remove the configuration.
By default, an MSDP peer is not a member of any Mesh Group.
Example
# Configure the MSDP peer with address 125.10.7.6 to be a member of the Mesh
Group Grp1.
<Quidway> system-view
[Quidway] msdp
[Quidway-msdp] peer 125.10.7.6 mesh-group Grp1
6.1.14 peer minimum-ttl
Syntax
peer peer-address minimum-ttl ttl
undo peer peer-address minimum-ttl
View
MSDP view
Parameter
peer-address: Address of the MSDP peer to which the TTL limitation applies.
ttl: TTL threshold, ranging from 0 to 255.
Description
Use the peer minimum-ttl command to configure the minimum TTL (Time-to-Live)
value of the multicast data packets encapsulated in SA messages to be sent to
specified MSDP peer.
Use the undo peer minimum-ttl command to restore the default TTL threshold.
By default, the value of TTL threshold is 0.
To Next Page
Loading...
Need help?
General