Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-51
source-ip: Source IP address.
destination-ip: Destination IP address.
dead: Dead interval time.
minimal: Sends multiple Hello packets within 1 second. The fixed dead interval is 1
second.
multi-hello: Sends multiple Hello packets.
packets: Number of sent Hello packets, in the range of 3 to 10.
Description
Use the sham-link command to run Fast Hello function on the sham-link link, that is, to
specify multiple Fast Hello packets to be sent within one second. The default dead
interval time is one second.
Example
# Specify the sham-link link 1.1.1.1 2.2.2.2 to run Fast Hello Function. The dead interval
time is one second. Five Hello packets are sent within one second.
[Quidway-ospf-1] area 0.0.0.0
[Quidway-ospf-1-area-0.0.0.0] sham-link 1.1.1.1 2.2.2.2 dead minimal
multi-hello 5
3.1.53 snmp-agent trap enable ospf
Syntax
snmp-agent trap enable ospf [ process-id ] [ ifstatechange | virifstatechange |
nbrstatechange | virnbrstatechange | ifcfgerror | virifcfgerror | ifauthfail |
virifauthfail | ifrxbadpkt | virifrxbadpkt | iftxretransmit | viriftxretransmit |
originatelsa | maxagelsa | lsdboverflow | lsdbapproachoverflow ]
undo snmp-agent trap enable ospf [ process-id ] [ ifstatechange | virifstatechange
| nbrstatechange | virnbrstatechange | ifcfgerror | virifcfgerror | ifauthfail |
virifauthfail | ifrxbadpkt | virifrxbadpkt | iftxretransmit | viriftxretransmit |
originatelsa | maxagelsa | lsdboverflow | lsdbapproachoverflow ]
View
System view
Parameter
process-id: ID of an OSPF process. The command is applied to all current OSPF
processes if you do not specify a process ID.
ifstatechange, virifstatechange, nbrstatechange, virnbrstatechange, ifcfgerror,
virifcfgerror, ifauthfail, virifauthfail, ifrxbadpkt, virifrxbadpkt, iftxretransmit,
To Next Page
Loading...
Need help?
General