Huawei Quidway S8500 Series User Manual

Command Manual – Port
Quidway S8500 Series Routing Switches
Chapter 2 Ethernet Link Aggregation Configuration
Commands
Huawei Technologies Proprietary
2-1
Chapter 2 Ethernet Link Aggregation
Configuration Commands
2.1 Ethernet Link Aggregation Configuration Commands
2.1.1 debugging lacp packet
Syntax
debugging lacp packet [ interface interface-type interface-number [ to interface-type
interface-number ] ]
undo debugging lacp packet [ interface interface-type interface-number [ to
interface-type interface-number ] ]
View
System view
Parameter
interface interface-type interface-number [ to interface-type interface-number ]:
Specifies a port or ports. The command without the parameter to specifies one port,
while the command with the parameter to specifies several contiguous ports.
interface-type indicates port type. interface-number indicates port number. For more
information, see the parameter description of the interface command.
Description
Use the debugging lacp packet command to enable LACP packet debugging for the
port. If you do not specify a port, the command enables packet debugging on all
LACP-enabled ports.
Use the undo debugging lacp packet command to disable LACP packet debugging
for the port.
Example
# Enable LACP packet debugging for Ethernet port Ethernet1/1/1.
<Quidway> debugging lacp packet interface ethernet1/1/1

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English