Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-28
timeout interval: Specifies the interval during which the debugging all switch is on.
The value ranges from 1 to 1440, in minutes. With this configuration, all debugging take
the time at which they are enabled as the start time, and take effect during the
predefined time. And after that, all debuggings are disabled.
module-name: Specifies the module name.
debugging-option: Debugging option.
Description
Use the debugging command to enable the system debugging.
Use the undo debugging command to disable the system debugging.
By default, all the debugging processes are disabled.
Ethernet Switch provides various kinds of debugging functions for technical support
personnel and experienced maintenance staff to troubleshoot the network.
Enabling the debugging will generate a large amount of debugging information and
decrease the system efficiency. Specially, network system may collapse after all the
debugging is enabled by debugging all command. So it is not suggested to use the
debugging all command. It is convenient for the user to disable all the debugging with
undo debugging all command.
Related command: display debugging.
Example
# Enable IP Packet debugging.
<Quidway> debugging ip packet
IP packet debugging switch is on.
The above output shows that the IP packet debugging is enabled.
4.4.2 display diagnostic-information
Syntax
display diagnostic-information
View
Any view
Parameter
None
To Next Page
Loading...
Need help?
General