Huawei Quidway S8500 Series - Traffic-Priority

Command Manual – QoS/ACL
Quidway S8500 Series Routing Switches Chapter 2 QoS Commands
Huawei Technologies Proprietary
2-37
Example
# Set the traffic parameter index to 10, committed average information rate to 8192
Kbps, committed burst size to 2000 bytes, and the maximum bust size to 2500 bytes.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] traffic-params 10 cir 8192 cbs 2000 ebs 2500
2.1.34 traffic-priority
Syntax
I. Command Format Which Only Applies IP Group ACL
In Ethernet port view:
traffic-priority inbound ip-group { acl-number | acl-name } [ rule rule [ system-index
index ] ] { auto | remark-policed-service { trust-dscp | dscp dscp-value | untrusted
dscp dscp-value cos cos-value local-precedence local-precedence drop-priority
drop-level } }
undo traffic-priority inbound ip-group { acl-number | acl-name } [ rule rule ]
In VLAN view:
traffic-priority inbound ip-group { acl-number | acl-name } [ rule rule [ system-index
index ] ] { auto | remark-policed-service { trust-dscp | dscp dscp-value | untrusted
dscp dscp-value cos cos-value local-precedence local-precedence drop-priority
drop-level } } slot slotid
undo traffic-priority inbound ip-group { acl-number |
acl-name } [ rule rule ] slot
slotid
II. Command Format Which Applies IP Group and Link Group ACL at Same
time
In Ethernet port view:
traffic-priority inbound ip-group { acl-number | acl-name } { rule rule link-group
{ acl-number | acl-name } [ rule rule [ system-index index ] ] | link-group { acl-number
| acl-name } rule rule } { auto | remark-policed-service { trust-dscp | dscp
dscp-value | untrusted dscp dscp-value cos cos-value local-precedence
local-precedence drop-priority drop-level } }
undo traffic-priority inbound ip-group { acl-number | acl-name } { rule rule
link-group { acl-number | acl-name } [ rule rule ] | link-group { acl-number | acl-name }
rule rule }
III. Command Format Which Only Applies Link Group ACL
In Ethernet port view: