Huawei Quidway S8500 Series - Display Ntp-Service Sessions; Display Ntp-Service Status

Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 7 NTP Configuration Commands
Huawei Technologies Proprietary
7-2
Example
# Enable NTP access control debugging.
<Quidway> debugging ntp-service access
7.1.2 display ntp-service sessions
Syntax
display ntp-service sessions [ verbose ]
View
Any view
Parameter
verbose: Indicates to display the detail information about the SESSIONS.
Description
Use the display ntp-service sessions command to display the status of all the
SESSIONS maintained by NTP service provided by the local equipment.
By default, the status of all the SESSIONS maintained by NTP service provided by the
local equipment will be displayed.
When you configure this command without the verbose parameter, the Ethernet switch
will display the brief information about all the SESSIONS it maintains.
With the verbose parameter configured, Ethernet switch will display the detail
information about all the SESSIONS it maintains.
Example
# Display status of all SESSIONS maintained by the local device NTP service.
<Quidway> display ntp-service sessions
source reference stra reach poll now offset delay disper
********************************************************************
[12345]127.127.1.0 LOCAL(0) 7 377 64 16 0.0 0.0 0.9
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
7.1.3 display ntp-service status
Syntax
display ntp-service status
View
Any view