Command Manual – Getting Started
Quidway S8500 Series Routing Switches Chapter 1
Commands Used to Log in to Switch
Huawei Technologies Proprietary
1-24
View
User interface view
Parameter
None
Description
Use the shell command to enable terminal service of a user interface.
Use the undo shell command to disable the terminal service of a user interface.
By default, terminal service is enabled.
When using the undo shell command, note the following points.
z The undo shell command can only be used on the user interfaces other than the
Console user interface.
z You cannot use this command on the user interface via which you log in.
z You will be asked to confirm before executing this command on any legal user
interface.
Example
# Disable terminal service on the vty user interface 0 to 4 after logging in to the switch
via user interface 0.
<Quidway>system-view
System View: return to User View with Ctrl+Z.
[Quidway] user-interface vty 0 4
[Quidway-ui-vty0-4] undo shell
1.1.27 speed
Syntax
speed speed-value
undo speed
View
User interface view
Parameter
speed-value: Specifies the transmission rate on the user interface in bit/s, which can be
300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200. The default rate is
9600bit/s.
To Next Page
Loading...
