Command Manual – Security
Quidway S8500 Series Routing Switches Chapter 1
802.1x Configuration Commands
Huawei Technologies Proprietary
1-11
This command is used to set the base for 802.1x to perform access control, namely
authenticate the users, on the specified interface. When macbased is adopted, the
user access this interface must be authenticated independently, and if one successful
authentication user is to finish network service, the other accessed users can still use
network service. When portbased is adopted, if only the first access user by this
interface can be authenticated successfully, the other access users followed can be
considered authenticated successfully automatically, but if the first one finish the
network service, the other accessed users’ network service will be rejected . .
This command has effect on the interface specified by the parameter interface-list
when executed in system view. It has effect on all the interfaces when no interface is
specified. The parameter interface-list cannot be input when the command is executed
in Ethernet interface view and it has effect only on the current interface.
Related command: display dot1x.
Example
# Authenticate the supplicant based on the interface number on Ethernet 3/1/1.
[Quidway] dot1x port-method portbased interface ethernet 3/1/1
1.1.10 dot1x quiet-period
Command
dot1x quiet-period
undo dot1x quiet-period
View
System view
Parameter
None
Description
Use the dot1x quiet-period command to enable the Quiet-period timer.
Use the undo dot1x quiet-period command to disable this timer.
If an 802.1x user has not passed the authentication, the Authenticator will keep quiet for
a while (which is specified by quiet-period timer) before launching the authentication
again. During the quiet period, the Authenticator does not do anything related to 802.1x
authentication.
By default, Quiet-period timer is disabled.
Related command: display dot1x , dot1x timer.
To Next Page
Loading...
Need help?
General