Huawei Quidway S8500 Series User Manual

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 1 Static Route Configuration Commands
Huawei Technologies Proprietary
1-16
*NextHop: 2.2.2.1 Interface: 2.2.2.1(Vlan-interface2)
State: <Int ActiveU Retain Unicast>
Age: 20:08:05 Cost: 0/0
First, display statistics of the whole routing table and then output detailed information of
every route entry in turn. The meaning of route status is shown in
Table 1-2, and the
statistics of routing table is shown in the following table.
Table 1-5 Description of the fields of the display ip routing-table verbose command
Field Description
Holddown Number of held-down routes
Delete Number of deleted routes
Hidden Number of hidden routes
1.2 Static Route Configuration Commands
1.2.1 delete static-routes all
Syntax
delete static-routes all
View
System view
Parameter
None
Description
Use the delete static-routes all command to delete all the static routes.
The system will request your confirmation before it deletes all the configured static
routes.
Related commands: ip route-static, display ip routing-table.
Example
# Delete all the static routes in the router.
[Quidway] delete static-routes all
This will erase all unicast static routes and their configurations, you must
reconfigure all static routes
Are you sure to delete all the static routes?[Y/N]

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English