Huawei Quidway S8500 Series - Slave Switchover; Slave Update Configuration

Command Manual – Reliability
Quidway S8500 Series Routing Switches Chapter 2
HA Configuration Commands
Huawei Technologies Proprietary
2-4
2.1.6 slave switchover
Syntax
slave switchover
View
User view
Parameter
None
Description
Use the slave switchover command to start the master-slave switchover manually.
In the environment in which the slave board is available and master in real-time backup
state, the user can inform the slave board of a master-slave switchover by using a
command if he expects the slave board to operate in place of the master board. After
the switchover, the slave board will control the system and the original master board will
be forced to reset.
Example
# Enable master-slave switchover manually.
<Quidway> slave switchover
Caution!!! Confirm switch slave to master[Y/N]?y
Starting.....
RAM Line....OK
2.1.7 slave update configuration
Syntax
slave update configuration
View
User view
Parameter
None
Description
Use the slave update configuration command to manually synchronize the
configuration file between the master and slave boards.
Related command: slave auto-update config.