Huawei Quidway S8500 Series - Aggregate

Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 2 BGP/MPLS VPN Configuration Commands
Huawei Technologies Proprietary
2-1
Chapter 2 BGP/MPLS VPN Configuration
Commands
 Note:
Refer to the 05-Routing Protocol Commands Module of the Quidway S8500 Switches
Command Manual for the details about the if-match interface, if-match acl, if-match
ip-prefix, if-match ip next-hop, if-match cost, if-match tag, apply ip next-hop,
apply local-preference, apply origin, apply tag commands and the related
commands.
2.1.1 aggregate
Syntax
aggregate address mask [ as-set | attribute-policy route-policy-name |
detail-suppressed | origin-policy route-policy-name | suppress-policy
route-policy-name ]*
undo aggregate address mask [ as-set | attribute-policy route-policy-name |
detail-suppressed | origin-policy route-policy-name | suppress-policy
route-policy-name ]*
View
VPN-instance subaddress family view
Parameter
address: IP address of an aggregated route, in dotted decimal format.
mask: Network mask of an aggregated route, in dotted decimal format.
as-set: Generates routes with AS sets.
detail-suppressed: Advertises only aggregated routes.
suppress-policy route-policy-name: Suppresses advertisement of some selected
specific routes.
origin-policy route-policy-name: Selects source route for aggregation.
attribute-policy route-policy-name: Sets the attributes of an aggregated route.