Huawei Quidway S8500 Series User Manual

Command Manual – Network Protocol
Quidway S8500 Series Routing Switches Chapter 1 IP Address Configuration Commands
Huawei Technologies Proprietary
1-6
Description
Use the ip host command to configure the host name and the host IP address.
Use the undo ip host command to cancel the host name and the host IP address.
By default, host name and corresponding IP address are null.
Related command: display ip host.
Example
# Set Lanswtich1’s IP address to be 10.110.0.1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ip host Lanswitch1 10.110.0.1
1.1.5 ip-protect enable
Syntax
ip-protect enable
undo ip-protect
View
VLAN interface view
Parameter
None
Description
Use the ip-protect enable command to enable IP address protection.
Use the undo ip-protect command to disable IP address protection.
After IP address protection is enabled, the current interface will no longer dynamically
learn ARP mapping entries, and existing dynamic ARP mapping entries will be
removed. At the same time, the switch will enable the MAC address auto filling function,
so that the user can configure static ARP entries that have only IP address.
By default, IP address protection is disabled.
You can use the display this command to view the status of IP address protection
(enabled/disabled) for the current VLAN interface.
Example
# Enable IP address protection for Vlan-interface 2.
<Quidway> system-view
System View: return to User View with Ctrl+Z.

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English