Command Manual – NAT&URPF&VPLS
Quidway S8500 Series Routing Switches Chapter 1
NAT Configuration Commands
Huawei Technologies Proprietary
1-19
Parameter
src-address: Source IP address of the log packets, which defaults to 0.0.0.0.
Description
Use the ip userlog nat export source-ip command to set the source IP address and
port number of log packets.
Use the undo ip userlog nat export source-ip command to restore the default source
IP address and port number of log packets.
Example
# Set the source IP address and port number of log packets to 169.254.1.1 and 200
respectively.
[Quidway] ip userlog nat export source-ip 169.254.1.1 200
1.2.6 ip userlog nat export version
Syntax
ip userlog nat export version version-number
undo ip userlog nat export version
View
System view
Parameter
version-number: Version of the log packets, which defaults to 1.
Description
Use the ip userlog nat export version command to set the version of log packets.
Use the undo ip userlog nat export version command to restore the default version
of log packets.
Example
# Set the version of the log packets to 1.
[Quidway] ip userlog nat export version 1
1.2.7 ip userlog nat mode flow-begin
Syntax
ip userlog nat mode flow-begin
undo ip userlog nat mode flow-begin
To Next Page
Loading...
