Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-9
undo preference
View
RIP view
Parameter
value: Preference level, ranging from 1 to 255. By default, the value is 100.
Description
Use the preference command to configure the route preference of RIP.
Use the undo preference command to restore the default preference.
Every routing protocol has its own preference. Its default value is determined by the
specific routing policy. The preference will finally determine the routing algorithm to
obtain the optimal route in the IP routing table. This command can be used to modify
the RIP preference manually.
Example
# Specify the RIP preference as 20.
[Quidway-rip] preference 20
2.1.11 reset
Syntax
reset
View
RIP view
Parameter
None
Description
Use the reset command to reset the system configuration parameters of RIP.
When you need to re-configure parameters of RIP, this command can be used to
restore to the default setting.
Example
# Reset the RIP system.
[Quidway-rip] reset