Huawei Quidway S8500 Series - Rmon Statistics

Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 6 RMON Configuration Commands
Huawei Technologies Proprietary
6-13
z Comparing the sample values against the predefined threshold and take further
actions (see
Table 6-7).
Table 6-7 Handling extended alarm entries
Item Handling
The calculated sample value is greater
than the upper limit threshold-value1.
Triggers the defined event event-entry1
The calculated sample value is less than
the lower limit threshold-value2.
Triggers the defined event event-entry2
Example
# Add an extended alarm entry in the fifth line of the extended alarm table. Perform
operation on the corresponding variant by means of the formular
((.1.3.6.1.4.1.43.45.1.6.1.2.1.1.2.1-.1.3.6.1.4.1.43.45.1.6.1.2.1.1.3.1)*100/.1.3.6.1.4.1.
43.45.1.6.1.2.1.1.2.1) to get the port utilization of Gigabit Ethernet interface 1/1/1.
Monitor the operation results at the sampling interval of 10 seconds. When the variation
rate exceeds the upper threshold 50, trigger event 1; when the variation rate gets below
the lower threshold 2, trigger event 2. Set the alarm instance sampling type to “forever”,
and set the owner of the extended alarm table to “user1”.
<Quidway> system-view
[Quidway] rmon prialarm 5
((.1.3.6.1.4.1.43.45.1.6.1.2.1.1.2.1-.1.3.6.1.4.1.43.45.1.6.1.2.1.1.3.1)*1
00/.1.3.6.1.4.1.43.45.1.6.1.2.1.1.2.1) ifUtilization.GigabitEthernet1/1/1
10 changeratio rising_threshold 50 1 falling_threshold 5 2 entrytype forever
owner user1
# Delete line 10 from the extended RMON alarm table.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] undo rmon prialarm 10
6.1.11 rmon statistics
Syntax
rmon statistics entry-number [ owner text-string ]
undo rmon statistics entry-number
View
Ethernet port view