Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-30
OSPF Process 1 with Router ID 1.1.1.1
Virtual Links
Virtual-link Neighbor-id -> 2.2.2.2, State: Full
Cost: 0 State: Full Type: Virtual
Transit Area: 0.0.0.2
Timers: Hello 10, Dead 40, Poll 0, Retransmit 5, Transmit Delay 1
Table 3-15 Description of the fields of the display ospf vlink command
Field Description
Virtual-link Neighbor-id Router ID of virtual-link neighbor router
State State
Interface IP address the interface on the virtual link
Cost Route cost of the interface
Type Type: virtual link
Transit Area
ID of transit area that the virtual link passes, and it
cannot be backbone area, Stub area and NSSA area
OSPF timers, defining as follows:
Hello Interval of Hello packet
Dead Interval of dead neighbors
Poll Interval of poll
Timers
Retransmit
Interval for retransmitting LSA on the
interface
Transmit Delay Delay time of transmitting LSA on the interface
3.1.28 filter-policy export
Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ routing-protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name} export [ routing-protocol ]
View
OSPF view
Parameter
acl-number: Number of a basic or advanced access control list.
ip-prefix-name: Name of the address prefix list used for filtering the destination
addresses in routing information.