Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 4 RPR Port Configuration Commands
Huawei Technologies Proprietary
4-2
Parameter
all: All RPR debugging.
topology: RPR topology database modular debugging switch.
protection: RPR protection modular request debugging switch.
controlframe: RPR control frame processing debugging switch.
Mac: RPR ring selection MAC module debugging switch.
ringselection: RPR ring selection module debugging switch.
tp-frame: RPR TP frame processing debugging switch.
Description
Use the debugging rpr command to enable RPR debugging.
Use the undo debugging rpr command to disable RPR debugging.
By default, RPR debugging is disabled.
Example
# Enable all debugging for an RPR port.
<Quidway> debugging rpr all
4.1.3 display interface
Syntax
display interface [ interface-type | interface-type interface-number ]
View
Any view
Parameter
interface-type: Port type.
interface-number: Port number.
Note that, there are two physical ports on the RPR panel. However, the physical ports
presently appear as sub-interfaces.
Description
Use the display interface command to view the RPR port configuration and status
information. If you do not specify both port type and port number, the command
displays the information about all ports on the switch. If you only specify port type, the
command displays the information about all ports of the specified type. If you specify
both port type and port number, the command displays the information about the
specified port. If you do not specify port number, the command displays all port
To Next Page
Loading...
