Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 5 SNMP Configuration Commands
Huawei Technologies Proprietary
5-15
Description
Use the snmp-agent sys-info command to configure system information such as
geographical location of the device, contact information for system maintenance and
version information of running SNMP.
Use the undo snmp-agent sys-info location command to restore the default value.
By default, the contact information for system maintenance is "R&D Beijing,Huawei
Technologies co.,Ltd.", the system information about geographical location is "Beijing
China", and the version information is " SNMPv3".
Related command: display snmp-agent sys-info.
Example
# Set the system maintenance information to "Dial System Operator at beeper #
27345".
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] snmp-agent sys-info contact Dial System Operator at beeper # 27345
5.1.15 snmp-agent target-host
Syntax
snmp-agent target-host trap address udp-domain host-addr [ udp-port
udp-port-number ] params securityname securityname [ v1 | v2c | v3
[ authentication | privacy ] ]
undo snmp-agent target-host host-addr securityname securityname
View
System view
Parameter
address: Specifies the address of the host which receives SNMP messages.
host-addr: IP address of the host.
udp-port udp-port-number: Specifies the UDP port number of the host to receive the
SNMP notification.
v1: Represent the version of SNMPV1.
v2c: Represent the version of SNMPV2C.
v3: Represent the version of SNMPV3.
securityname: Specifies the community name, ranging 1 to 32 bytes. It can be the
community name of SNMPv1/v2c or the user name of SNMPv3.
authentication: Configures to authenticate the packet without encryption.
To Next Page
Loading...
