Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-24
Address Type Refcount Intf Addr Intf Name
---------------------------------------------------------------------
202.38.160.1 Direct 3 202.38.160.1 Vlan-interface2
202.38.160.2 Neighbor 1 202.38.160.1 Vlan-interface2
Table 3-9 Description of the fields of the display ospf nexthop command
Field Description
Address Address of next hop
Type Type of next hop
Refcount
Reference count of the next hop, i.e., number of routes using this
address as the next hop
Intf Addr IP address of the outgoing interface to the next hop
Intf Name The outgoing interface to the next hop
3.1.22 display ospf peer
Syntax
display ospf [ process-id ] peer [ brief ]
View
Any view
Parameter
process-id: Process ID of OSPF. The command is applied to all current OSPF
processes if you do not specify a process ID.
Description
Use the display ospf peer command to view information about OSPF peers.
Use the display ospf peer brief command to view the brief information of every peer in
OSPF, mainly the numbers of peers at all states in every area.
Example
# View the neighbor brief information of OSPF.
<Quidway> display ospf peer brief
OSPF Process 1 with Router ID 85.1.1.1
Neighbor Brief Information
Virtual Link:
Router ID Address Pri Interface State
To Next Page
Loading...
Need help?
General