Huawei Quidway S8500 Series - Retry Stop-Accounting; Secondary Accounting

Command Manual – Security
Quidway S8500 Series Routing Switches
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
Huawei Technologies Proprietary
2-60
<Quidway> reset stop-accounting-buffer hwtacacs-scheme Huawei
2.3.14 retry stop-accounting
Syntax
retry stop-accounting retry-times
undo retry stop-accounting
View
HWTACACS view
Parameter
retry-times: The maximum number of stop-accounting request attempts. It is in the
range 1 to 300 and defaults to 100.
Description
Use the retry stop-accounting command to enable stop-accounting packet
retransmission and configure the maximum number of stop-accounting request
attempts.
Use the undo retry stop-accounting command to restore the default setting.
By default, stop-accounting packet retransmission is enabled and up to 100 packets
are allowed to be transmitted for each request.
Related command: reset stop-accounting-buffer, hwtacacs scheme, and display
stop-accounting-buffer.
Example
# Enable stop-accounting packet retransmission and allow up to 50 packets to be
transmitted for each request.
[Quidway] retry stop-accounting 50
2.3.15 secondary accounting
Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
HWTACACS view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal format.