Huawei Quidway S8500 Series - Mpls Lsr-ID; Snmp-Agent Trap Enable Ldp

Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 1 MPLS Basic Configuration Commands
Huawei Technologies Proprietary
1-7
1.1.8 mpls lsr-id
Syntax
mpls lsr-id ip-address
undo mpls lsr-id
View
System view
Parameter
ip-address: LSR ID, in the format of IP address, used to identify an LSR.
Description
Use the mpls lsr-id command to configure an LSR ID.
Use the undo mpls lsr-id command to delete an LSR ID.
By default, no LSR has an ID.
You must configure the mpls lsr-id command first and then you can use the other
MPLS-related commands.
An LSR ID is in the format of IP address, thus a loopback address is recommended.
Related command: display mpls interface.
Example
# Set the LSR ID to 202.17.41.246.
<Quidway>system-view
[Quidway] mpls lsr-id 202.17.41.246
% Info: Mpls lsr-id changed.
1.1.9 snmp-agent trap enable ldp
Syntax
snmp-agent trap enable ldp
undo snmp-agent trap enable ldp
View
System view
Parameter
None