Huawei Quidway S8500 Series User Manual

Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 1 MPLS Basic Configuration Commands
Huawei Technologies Proprietary
1-6
<Quidway>system-view
[Quidway] mpls
[Quidway-mpls] lsp-trigger all
1.1.7 mpls
Syntax
mpls
undo mpls
View
System view, VLAN interface view
Parameter
None
Description
In system, input the mpls command for an initial use to enable MPLS function globally
and enter MPLS view. Later you can go straight to the MPLS view with this command.
Use the mpls command in VLAN interface view to enable MPLS on the VLAN
interface.
Use the undo mpls command to disable MPLS function in the system view or on the
VLAN interface.
By default, you cannot enter this view.
After executing the command, you can enter MPLS view. Only after you enter MPLS
view, can you configure other MPLS commands.
You must configure the mpls lsr-id command first and then you can enter MPLS view.
Example
# Enter MPLS view from system view.
<Quidway>system-view
[Quidway] mpls
[Quidway-mpls]
# Execute the mpls command in interface view.
[Quidway] vlan 201
[Quidway-Vlan201] port gigabitethernet 2/1/1
[Quidway-Vlan201] quit
[Quidway] interface vlan-interface 201
[Quidway-vlan-interface201] mpls
% Info: MPLS in the interface is starting, please wait...OK

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English