Huawei Quidway S8500 Series - Display Isis Peer

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-8
4.1.8 display isis peer
Syntax
display isis peer [ verbose ]
View
Any view
Parameter
verbose: When this parameter is configured, the area address carried in the Hello
packet from the neighbor will be displayed. Otherwise, only the universal information
will be displayed.
Description
Use the display isis peer command to view IS-IS peer information.
The display isis peer verbose command yields not only all the outputs of the display
isis peer command, but also the area address, Uptime and IP address of the directly
connected interface of the peer.
Example
# Display detailed information about IS-IS neighbors.
<Quidway> display isis peer verbose
System ID Interface Circuit ID State HoldTime Type Pri
0002.0000.0000 Vlan-interface251 0002.0000.0000.0a Up 6s L1 64
Area Address: 00.0001
IP Address: 192.3.1.3 192.4.1.3 192.5.1.3 192.6.1.3 192.7.1.3 192.8.1.3
192.9.1.3 192.10.1.3 192.11.1.3
Period: 22:27:42
System ID Interface Circuit ID State HoldTime Type Pri
0003.0000.0000 Vlan-interface251 0002.0000.0000.0a Up 22s L1 64
Area Address: 00.0001
IP Address: 192.3.1.2
Period: 22:31:18
# View IS-IS peer Information.
<Quidway> display isis peer
System ID Interface Circuit ID State HoldTime Type Pri
0002.0000.0000 Vlan-interface251 0002.0000.0000.0a Up 6s L1 64
0003.0000.0000 Vlan-interface251 0002.0000.0000.0a Up 22s L1 64