Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 4 RPR Port Configuration Commands
Huawei Technologies Proprietary
4-27
<Quidway> system-view
[Quidway] interface RPR 2/1/1.1
[Quidway-RPR 2/1/1.1]sdh threshold sd-ber 6
4.1.27 shutdown
Syntax
shutdown
undo shutdown
View
RPR logical/physical port view
Parameter
None
Description
Use the shutdown command to disable the RPR port.
Use the undo shutdown command to enable the RPR port.
On a ring network, a large part of node traffic needs to be forwarded. To reduce the
influence on forwarded traffic, you may need to carry out the shutdown command on
the RPRPOS logical port. After the execution of the shutdown command, the logical
port is in the Down state, and the locally added/dropped services are disabled.
After you disable the RPR physical port by shutdown, the corresponding laser is
turned off, and the corresponding protection takes place..
Example
# Disable RPRPOS logical port RPR2/1/1.
<Quidway> system-view
[Quidway] interface RPR 2/1/1.1
[Quidway-RPR2/1/1]shutdown
To Next Page
Loading...
