Huawei Quidway S8500 Series - Snmp-Agent Trap Enable

Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 5 SNMP Configuration Commands
Huawei Technologies Proprietary
5-16
privacy: Configures to authenticate and encrypt the packet.
Description
Use the snmp-agent target-host command to configure destination of SNMP
notification.
Use the undo snmp-agent target-host command to cancel the host that receives
SNMP notification.
The snmp-agent target-host command and the snmp-agent trap enable command
should be used at the same time. Use the snmp-agent trap enable command to
enable the device to transmit Trap packets. The snmp-agent trap enable command
and snmp-agent target-host command should be used at the same time on the host
to enable notify message sending.
 Note:
If the version of SNMP message is v3, the packet authentication encryption mode
specified by the command must be consistent with configuration for SNMP group to
which the securityname belongs.
Related command: snmp-agent trap enable, snmp-agent trap source and
snmp-agent trap life, snmp-agent group, snmp-agent usm-user.
Example
# Enable sending Trap message to 10.1.1.1 with community name public.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] snmp-agent trap enable
[Quidway] snmp-agent target-host trap address udp-domain 10.1.1.1 params
securityname public
5.1.16 snmp-agent trap enable
Syntax
snmp-agent trap enable [ bgp [ backwardtransition | established ]* | configuration
| flash | ospf [ process-id ] [ ospf-trap-list ] | ldp | lsp | standard [ authentication |
coldstart | linkdown | linkup | warmstart ]* | system | vrrp [ authfailure |
newmaster ] ]
undo snmp-agent trap enable [ bgp [ backwardtransition | established ]* |
configuration | flash | ospf [ process-id ] [ ospf-trap-list ] | ldp | lsp | standard